Shaft Struts
The project involved the fabrication of shaft struts, which are essential structural components used to ...
Machining Assy Linear Calibration for 358.96 mm Outer Diameter Pipe
PT Mitra Karya Sarana is executing a linear calibration project for a 358.96 mm diameter pipe made of Inconel 625, commissioned by Cladtek.
Machining Rough Material
Learn about the Machining Rough Material project by PT Mitra Karya Sarana for PT. SPM Surface Indonesia, focusing on the precision machining of AISI 4140 steel components.
Machining and J-Bevelling of 16-inch Inconel 625 Pipe
The project focuses on advanced machining of Inconel 625 pipes, ensuring high quality and performance.
Id Clad Pipe Machining
The Id Clad Pipe Machining project innovatively enhances machining efficiency while ensuring environmental responsibility and high quality.
Hydro End Cap Blank OD Pipe 18-Inch
The Hydro End Cap project delivered high-quality 18-inch caps for Cladtek, ensuring performance and reliability.
